MODEL NO. 36 REDIN "WASH & GRIND" GEAR DEBURRING/BRUSHING MACHINE

MODEL NO. 36 REDIN "WASH & GRIND" GEAR DEBURRING/BRUSHING MACHINE SERIAL NO. 36-36 (NEW 1998) SUITABLE FOR THE AUTOMATIC DEBURRING/BRUSHING OF SPUR AND HELICAL GEARS, STRAIGHT AND SPIRAL BEVEL GEARS, SPROCKETS, WORM-GEARS, AND SIMILAR WORK-PIECES UP TO 20" (508MM) DIAMETER AND 6" (152MM) FACE BASIC MACHINE CONFIGURATION / WITH AUTO CYCLE MACHINE SPECIALLY CONFIGURED TO ALLOW WORK-PIECE TO BE LOADED THROUGH A “ROOF-HATCH” VIA OVERHEAD GANTRY-CRANE. WHILE ON AUTOMATIC, THE “START” BUTTON AND THE “SECOND-HAND” BUTTON ARE PUSHED SIMULTANEOUSLY UNTIL THE PNEUMATICALLY POWERED FRONT DOORS ARE CLOSED AND THE DEBURRING CYCLE HAS STARTED. THE WORK-TABLE WITH THE WORK-PIECE IS ROTATED CLOCKWISE FOR TWO REVOLUTIONS WHILE IT IS BEING DEBURRED. THE “SKIVE-BRUSH” UNIT IS ALSO ROTATING CLOCKWISE AT THIS TIME. THE “UPPER” DEBURRING TOOL WITH AIR-POWERED MOTOR, AND THE “LOWER” SKIVE-TOOL WITH AIR-POWER MOTOR ARE ALSO OPERATING AT THIS TIME, WITH COOLANT BEING PUMPED ONTO THE WORK-PIECE AND SKIVE BRUSH STATION/UNIT. THE ROTATION OF THE WORK-SPINDLE AND WORK-PIECE IS THEN REVERSED (TO COUNTER-CLOCKWISE) FOR TWO REVOLUTIONS. THE SKIVE-BRUSH ROTATION IS ALSO REVERSED. DURING THE COUNTER-CLOCKWISE ROTATION, THE LOWER DEBURRING MOTOR ON THE RIGHT SIDE OF THE MACHINE IS IN OPERATION. COOLANT IS PUMPED ONTO THE PART AND THE SKIVE-BRUSH DURING THE FIRST COUNTER-CLOCKWISE REVOLUTION. DURING THE SECOND COUNTER-CLOCKWISE REVOLUTION, THE COOLANT IS SWITCHED OFF, AND DRYING AIR IS SPRAYED ONTO THE GEAR PART. EQUIPMENT / FEATURES: FULL MACHINE ENCLOSURE WITH FACILITY FOR DUST EXHAUST AND PNEUMATICALLY OPERATED FRONTAL GUARD DOOR, W/SUBSEQUENT PNEUMATIC SYSTEM MANIFOLDS, AND COOLANT FILTRATION SYSTEM ROTATING WORK-SPINDLE WITH PART FIXTURE 3-SPINDLE STATION ARRANGEMENT CONSISTING OF (1) RIGHT-HAND UPPER AIR-DRIVEN MOTORIZED CARBIDE GRINDING CUTTER WITH ADJUSTABLE BRACKET & STAND (1) LEFT-HAND LOWER AIR-DRIVEN MOTORIZED CARBIDE GRINDING CUTTER WITH ADJUSTABLE BRACKET & STAND (1) RIGHT-REAR MOUNTED PIVOT SKIVE BRUSH ASSEMBLY EMPLOYING STACKED SERIES OF WEILER 6” DIAMETER WIRE BRUSHES ALLEN BRADLEY PLC CONTROL WITH RS-LOGIX 500 SOFTWARE AND 550 ALLEN BRADLEY “PANEL-VIEW” CONTROL PANEL COMPLETE PNEUMATICS WITH LINES, FLOW-CONTROL VALVES, SOLENOIDS, GAUGES, ETC. FULL COMPLEMENT OF ELECTRICS (MOTORS/CONTROLS) (PRESENTLY ARRANGED FOR 480 VOLT, 60HZ OPERATION) FULL MACHINE DOCUMENTATION FOR MACHINE & CONTROLLER, WITH MACHINE DRAWINGS FOR PNEUMATIC, AND ELECTRICAL SYSTEM, PARTS LIST, ETC. NOTE: THIS MACHINE WAS BUILT SPECIFICALLY FOR A JOB AT CATERPILLAR. IT WILL PROBABLY TAKE SOME MODIFICATIONS TO DO YOUR SPECIFIC JOB. WE ARE NOT GOING TO RUN THIS MACHINE. PRICE: F.O.B. OUR WAREHOUSE