641 GLEASON “G-PLETE” HYPOID SPIRAL

641 GLEASON “G-PLETE” HYPOID SPIRAL

$39,500 (USD)

orCall 513-771-1952

Description

641 GLEASON “G-PLETE” HYPOID SPIRAL BEVEL GEAR GENERATING MACHINE NEW 1980, SERIAL NO. 763305, MODEL 641, SERIES G-PLETE SUITABLE FOR THE “COMPLETING” OF SPIRAL BEVEL, HYPOID, AND ZEROL BEVEL GEARS AND PINIONS UP TO 16” (406.4MM) DIAMETER, 2.6” (66MM) FACE-WIDTH, WITH 2 DP (MODULE 12.7) CUTTING CAPABILITY FEATURES / EQUIPMENT: HYDRAULIC CHUCKING ATTACHMENT LESS/DRAW-ROD & NUT ARRANGEMENT FOR FORMATE, INCLUDING CONTROLS FOR COMPLETING, ROUGHING & FINISHING PLUNGE FEED MECHANISM VARIABLE RATE-OF-ROLL ARRANGEMENT HELICAL MOTION FEATURE DOUBLE-ROLL ARRANGEMENT RATIO CONTROL MECHANISM ONE SINGLE SET-UP OF CHANGE GEARS FULL COMPLEMENT OF ELECTRICS (MOTORS/CONTROLS) COOLANT SYSTEM, PUMP TANK & PIPING AUTOMATIC CHIP SEPARATOR, INCLUDING AUTOMATIC CHIP WIPER SYSTEM AND AUGER-TYPE CHIP CONVEYOR PRICE: F.O.B. OUR WAREHOUSE

Specifications

Model641.0
Year1980
ConditionUsed
Serial Number763305.0
Stock Number28074
Root angle range-8° TO 90°
Gear diameter – maximum16.000" (406.40MM)
At the following ratios(USING 12” CUTTERS)
1 x 113.500" (342.90MM)
2 x 116.000" (406.40MM)
5 x 116.000" (406.40MM)
Maximum radial setting6.983" (177.40MM)
Diametral pitch – coarsest2.0 DP (12.70 MOD)
Full depth – maximum1.000" (25.40MM)
Face width – maximum2.600" (66.00MM)
Index range5 TO 10 INCLUSIVE
At large end3-29/32" (99.22MM)
Taper per foot39/64” (15.48MM)
Depth of taper6" (152.40MM)
Diameter of hole through spindle3.0625" (77.79MM)
Cycle time infinitely variable from4.5 SECONDS/TOOTH – MINIMUM
Offset above centre - maximum2.25" (57.15MM)
Machine centre to nose of spindle – maximum14.50” (368.30MM)
Electrical equipment60 HZ (50 HZ)
Cutter drive motor(10/5 HP) 1800/900 RPM (1500/750 RPM)
Hydraulic motor(5 HP) (1500 RPM)
Coolant motor(2 HP) (1000 RPM)
D.c. generating drive motor(6 HP) 1200 RPM
Electrical panel & chip removal system)131” X 85” (333 X 216CM)
Height83” (211CM)