MODEL NO. 517 GLEASON HYPOID BEVEL GEAR TESTER

MODEL NO. 517 GLEASON HYPOID BEVEL GEAR TESTER

$79,500 (USD)

orCall 513-771-1952

Description

MODEL NO. 517 GLEASON HYPOID BEVEL GEAR TESTER SERIAL NO. 162701 (NEW IN 1989) SUITABLE FOR TESTING THE RUNNING QUALITIES OF BEVEL AND HYPOID GEARS UP TO 42” (1067MM) DIAMETER, OPERATING AT A 90-DEGREE SHAFT ANGLE EQUIPMENT / FEATURES: HYDRAULIC CHUCKING ARRANGEMENT FOR BOTH GEAR AND PINION WORK-HEADS (LESS DRAW-IN BAR AND NUTS) OPTIONAL DRIVE-HEAD SPINDLE BORE (6” DIA. X .75" TAPER PER FT. X 3" LONG) POWER MOVEMENT OF DRIVE HEAD ( IN / OUT ) OPTIONAL BRAKE-HEAD SPINDLE BORE (3-29/32"DIA. X 39/64" TAPER PER FT., X 3" LONG) GEAR AND PINON SPINDLES WITH SPECIAL ANTI-FICTION, VIBRATION FREE BEARINGS AUTOMATIC BACKLASH CONTROL FOR PRESET BACKLASH SINE BAR SET-UP ARRANGEMENT IMPERIAL GRADUATED SCALES & DIALS MANUAL, HAND OPERATED BRAKE TO SIMULATE LOAD OPTIONAL AMMETER FOR CHECKING BRAKE LOAD OPTIONAL TWO-SPEED MOTOR AND CONTROL FOR DRIVE SPINDLE SPEEDS OF 600 AND 1200 RPM. FULL ELECTRICS (MOTORS/CONTROLS) (CONFIGURED FOR 480 VOLT 50/60 CYCLE OPERATION) PRICE: F.O.B. OUR WAREHOUSE

Specifications

Model517.0
Year1989
ConditionUsed
Serial Number162701.0
Stock Number28846
Maximum diameter of bevel gear at 90 degree shaft angle42" (1067MM)
Maximum diameter of bevel pinion at 90 degree shaft angle30" (765MM)
Or below pinion spindle center6” (152MM)
Pinion spindle taper hole diameter (at large end)6” (152.4MM)
Pinion spindle taper (per ft.).75” (19.05MM)
Pinion spindle taper depth3” (76.2MM)
Gear spindle taper hole diameter (at large end)3.9” (99.21MM)
Gear spindle taper (per ft.)0.618” (15.47MM)
Gear spindle taper depth3” (76.2MM)
Main motor7-1/2 HP 1800 RPM
Hydraulic motor¾ HP 1800 RPM
Machine overall length80” (2030MM)
Machine overall width73” (1900MM)
Machine overall height72” (1829MM)
Approx net weight 10,000 lbs.(4,536KGS)