17A GLEASON "HYPOID" BEVEL GEAR TESTER

17A GLEASON Hypoid Bevel Gear Testing Machine

Serial No. 25282

Suitable for the testing of straight bevel, spiral bevel, and hypoid 

gears with shafts intersecting at 90-degrees, with capacity to test

gears up to 20" (508mm) pitch diameter

EQUIPMENT / FEATURES:

Hydraulic work chucking cylinders on pinion

  and gear spindles, (less draw-in bar & nuts)

5-HP, 220/440 volt, 3-phase 60 cycle, 1670 rpm main drive motor

3/4 HP, 220/440 volt, 3-phase 60 cycle, 1745 rpm hydraulic motor

Pre-set backlash control

Brake spindle (2-19/64” bore dia. large end)

Adjustable drive pinion spindle  (3-29/32” bore dia. large end)

  w/crank handle & graduated dial

Load meter

Guards, covers, handwheels

Full complement of electrics, motors/controls)

PRINCIPAL SPECIFICATIONS:

Maximum offset of gear spindle above

  or below center of pinion spindle ……………………………….     3.5”       (88.9mm)

Maximum distance from center of gear spindle

  to nose of pinion spindle …………………………………….           12”        (304.8mm)

Minimum distance from center of gear spindle

  to nose of pinion spindle …………………………………….           6”         (152.4mm)

Maximum distance from center of pinion

  spindle to nose of gear spindle: ………………………………..…   7.75”     (196.85mm)

Minimum distance from center of pinion spindle

  to nose of gear spindle …………………………………………..      4.13”     (104.8mm)

Maximum diameter of gear with “zero” offset of gear spindle …..  20”        (508mm)

Machine dimensions (approx.) ……………………………………     60”x 73”x 60”

Machine net weight ……………………………………………….       5,300 Lbs.

PRICE:  F.O.B. OUR WAREHOUSE